ENFORA GSM1308 DRIVER DOWNLOAD

Your window should look like the following: In no event shall Unitronics be liable for any special, incidental, indirect or consequential damages of any kind, or any damages whatsoever arising out of or in connection with the use or performance of this information. Skip to Step Adobe and Acrobat are trademarks of Adobe Systems Inc. For technical support and customer service dealing with the modem itself, contact the company where you purchased the product. Within approximately 60 seconds the wakeup messages should be seen in the window. Any Terminal program should work, using the parameters in Step 1.

Uploader: Zuluhn
Date Added: 18 May 2007
File Size: 47.9 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 33157
Price: Free* [*Free Regsitration Required]

Refer to the following documentation for additional information, if required: Verify GPRS activation by sending the following command: Then leave the device unplugged.

Any Terminal program should work, using the parameters in Step 1. For the following tests, Java Runtime must be installed on the computer. The information can be accessed at the Enfora website http: These issues are addressed with the following configuration commands. The gsm11308 provided is subject to change without notice. Flashing, when attempting to register on a GSM network.

Indicates GSM network registration status. In the following examples, the SIM is for Cingular. To remove the card, slide the lock to the right and then press the card; a spring releases and partially ejects the card.

It’s a community-based project which helps ennfora repair anything. This limited warranty shall not be governed in any respect by the United Nations Convention on Contracts for the International Sale of Goods. IP addresses are dynamically assigned and can change. Your window should look like the following: Insert the SIM card here — please note that the enforra must be in the upper left hand corner. It’s a community-based project which helps to repair anything.

Enfora Spider SA – GSM1308 Quad Band, EDG1228 Quad Band

Pins that are not planned for usage can be left open without anything connected to them. Verify GSM status by sending the following command: All product names mentioned within this document are the trademark of their respective owners.

Store the current configuration to memory, send the following command: Enfora acknowledges that the installation, setup and transmission guidelines contained within this publication are guidelines, and that each installation may have variables outside of the guidelines contained herein. The other option available is the inclusion of four threaded holes for securing screws to be used to secure the device.

The examples will use the following information: The VSWR must be less than 2. System antenna gain should be dB for optimum performance. To write current config to memory, send the following command: If the USB-to-serial converter has not been installed, install the necessary drivers per the instruction supplied by gsm13308 USB-to-Serial device.

In this case, it is Gwm1308 During the warranty period applicable to the software or its media, Enfora, at its expense, will replace any defective software or media if purchaser gives written notification of the defect to the technical support department at Enfora during the applicable warranty period.

Enfora Spider SA GSM Quad Band, EDG Quad Band

With the maximum conducted power at 32 dBm, the maximum antenna gain is 4. Modem RS port pin-out D-type gm1308 pin female connector: Verify GPRS status by sending the following command: For technical support and customer service dealing with the modem itself, contact the company where you purchased the product. Enfora strongly recommends that all installations, hookups, transmissions, etc.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top